So you want to get a bash prompt but have lost the original serial cable included with your Stand Alone TiVo or have a DirecTiVo?  Well, this cable is for you!  It has a 1/8" stereo plug on one end that plugs into your TiVo or DirecTiVo and has a DB9 connector at the other that plugs into your PC's serial port.

You can use the 10' Long extension cable if your computer is just too far away.  Please note that longer cables runs may require lower data transmission speeds so try to use the 10' cable if possible.

You will need a new IDE cable with two drive connectors when installing a second hard drive in the HR10-250.
 

This Y-Cable gives you the additional power connector required for the HR10-250

 

Quantity	Part Number	Description	Your Cost	Click To Buy
	POWER-Y-CABLE	Internal Power Y-Cable for TiVo	$1.50

 

30 Piece Driver Set		39 Pc Driver & Socket Set

Both of these drive sets include the required drivers to open a TiVo.  The 30 piece set includes driver tips and driver handle.  The 39 piece set adds 9 sockets to the 30 piece kit.

The 30 piece set includes:
- Handle with magnetic bit holder and 1/4" hex drive
- 1/8, 5/32, 3/16, 1/4, 9/32" slot
- #0, #1, #2, #3 Phillips
- T-10, T-15, T-20, T-25, T-30, T-40 six lobe Torx*
- S-1, 2, 3  square
- 5/64", 3/32", 1/8", 5/32", 3/16", 7/32", 1/4", 5/16" hex
- Socket and bit adapters
- Rugged Plastic Case & Cover securely holds handle and bits

The 39 piece set adds:
- 7/32", 3/16", 5/16", 1/4", 11/32", 3/8", 7/16", 15/32", 1/2" Sockets

Quantity	Part Number	Description	Your Cost	Click To Buy
	DRIVER30	30 Piece Driver Set	$9.00
	DRIVERSKT39	39 Piece Driver & Socket Set	$11.00

 

Security Bit Tool Set - Driver Bits for TiVo

Well, lots of people have asked, so here it is.  This tool set includes the two drivers that are required to do the TiVo upgrade (T-10 & T15).  It is an overkill just for the TiVo upgrade, but it also includes many other security type bits will let  you get into lots of things that you shouldn't for years to come!  

This is a 30 piece set that includes:
- Handle with magnetic bit holder and 1/4" hex drive
- 5/32, 3/16, 1/4" slot
- #1, #2, #3 Phillips
- TT-7, TT-8, TT-9, TT-10, TT-15, TT-20, TT-25, TT-30, TT-40 tamper proof six lobe Torx*
- S-0, 1, 2, 3 security square
- 5/64", 3/32", 1/8", 5/32", 3/16", 7/32", 1/4" security hex
- Socket and bit adapters
- Rugged Plastic Case & Cover securely holds handle and bits

•  Have a nice power strip and can only use 2 outlets because of power transformers?

•  Get full use of your power strips and UPS outlets with our Jumper Cables

•  Just plug those big bulky power transformers into the Jumper Cable and then plug the
  Jumper Cable into one of those previously unusable outlets.

•  Available in one and two outlet versions

•  Heavy duty molded ends - UL listed

These kits are for the High Definition DirecTiVo - HR10-250

•  Appropriate hard disk drive - tested and pre-configured

•  High-quality mounting bracket and mounting hardware.

•  Torx T10 driver for opening case.

•  IDE ribbon cable to assure high-quality video playback.

•  Power-Y cable where needed

•  Installation instructions and online support.


 

•  InstantCake HD CD

With the Add-On Drive Kit, you just add an additional disk drive next to the original drive.  The Add-On Drive Kit will ADD hours to your existing hard drive so the total hours that you will have after the upgrade depends on how many hours your original TiVo has.  Your existing programming and settings are maintained.

With the Replacement Drive Kit, you remove the original drive and replace it with the new drive.  Since the Replacement Drive Kit replaces the original disk drive, the size of the Replacement Drive Kit will be the total hours that you will have after the upgrade.  Your existing programming and settings are not kept and you must go thru setup again but the Replacement Drive Kit will give the maximum storage available.