For TiVo Models: TCD24004A, TCD24008A and other models
with no side standoff.
The C-Clips will mount using the square
holes in
the bottom of the TiVo. These holes vary with
TiVo models so use the picture above as a guide
to find the two holes that are 4-5/8" apart. These
holes will be where the C-Clips mount.
This is what you get in the Standoff Kit:
(2) C-Clips
(4) Machine Screw #6 x 1/4" long with Lock-Washer
(2) #6 Flat Washers
Put a #6 x 1/4" Long Screw with Flat Washer in
the
outer square hole
from the bottom.
Position a C-Clip over the Screw and
tighten from the bottom.
Repeat for the other C-Clip
This is what the installed standoffs
look like.
Follow the mounting instructions for the
Series 2 mounting bracket Except at the
end, use the two shorter screws included
with the Spacer Kit instead of the Tapping
Screws included in the bracket kit.
